| “Show You’re Green” Awards Go to Eight
Sustainable—and Affordable—Projects
Summary:
The AIA Housing and Custom Residential Knowledge Community selected
eight “Show You’re Green” projects as examples of outstanding
housing that is both affordable and green. The winning projects will
be showcased online in the U.S. Department of Housing and Urban
Development’s Affordable Housing Design Advisor to demonstrate
diverse ways in which green practices are being integrated into
exemplary affordable housing. The projects and their architects were
recognized during AIA Housing and Custom Residential Knowledge
Community Awards Ceremony during the 2007 national convention in San
Antonio In May.
The winning projects considered the following AIA Affordable
Green Housing Guidelines:
- Community context
- Site design
- Building design
- Water conservation and management
- Energy efficiency
- Reduced and sustainable material use
- Recycling during construction and post-occupancy
- Indoor environmental quality healthy buildings
- Quality assurance/commissioning
- Other innovative design strategies.
Project: 150 Prospect Street Architect:
Boyes-Watson Architects Location: Somerville,
Mass. Just-A-Start Corporation, a community-based
nonprofit organization, commissioned Boyes-Watson Architects to
design an environmentally sensitive affordable rental housing
project that would maximize the number of units and square footage
allowable on the parcel, while preserving an existing Greek Revival
house and turning around a blighted site. Although constrained by
zoning requirements, the project met its goals of integrating the
development into its urban context, reinforcing the street edge
along Prospect Street, and creating both green areas and a parking
court that could have multiple uses. It has been a catalyst for
subsequent rehabilitations along a depressed city arterial road. The
Cambridge Historical Commission contributed funds to the successful
preservation of the 100-percent affordable Greek Revival
house. Photo © Mark Boyes-Watson, Boyes-Watson Architects.
Project: Denny Park Apartments Architect: Runberg Architecture
Group Location:
Seattle This project satisfies a growing need for
affordable housing downtown near park space and thereby promotes
economic sustainability and livable neighborhoods. The complex has
50 units in a mix of studios, one-, two-, and three-bedroom spaces;
20 are for households below 30 percent median income, 25 for those
below 50 percent median income, and 5 for those below 60 percent
median income. The ground floor responds to the urban fabric with
zero-lot-line development and commercial uses, while the massing of
the upper residential floors sensitively avoids crowding the
neighboring church by providing a courtyard as a buffer. Among other
sustainable design features, the project showcases stormwater
planters, the first to be built in Seattle for stormwater
detention. Photo © Michael Seidl, Mike Seidl Photography.
Project: Orchard Gardens Architect: MacArthur, Means &
Wells, Architects, PC Location: Missoula,
Mont. The 35 units at Orchard Gardens include a mix of
one-, two-, and three-bedroom spaces. Nine of the two- and
three-bedroom units are located in rowhouses, each with its own
washer and dryer, second floor, and backyard. A farmhouse building
contains six units, some with private porches. A large main building
contains 20 one- and two-bedroom units and 4 fully accessible units.
A community barn also provides a community room and kitchen for the
residents’ use. The project preserves the neighborhood tradition
through specific design elements such as corrugated metal roofing,
lap siding, and wood fencing. The common space is decorated with
public art that brings color and life to the central space. Fiber
cement siding, metal roofing, and concrete with 35-percent fly-ash
content was used throughout the project. Photo © Mark Fritch,
Mark Fritch Photography, LLC
Project: Pine Ridge Townhomes Architect: Living
Architecture Location:
Ketchum, Idaho This project features a mix of
affordable-housing and market-rate units. Living Architecture met
the needs of the affordable-housing user by working with the local
housing authority and conducting user meetings to determine
priorities, such as open space, open floor plans, daylight, and
views. The neighborhood is a mix of single-family and multifamily
projects. This design created the feel of a cluster of single-family
homes that fit in well with the neighborhood. There is no difference
in look between the affordable-housing and market-rate units. The
focal point of Pine Ridge is a beautiful central courtyard that
people can enjoy as they walk or drive by. The project’s buildings
incorporate passive solar design, super insulation in walls and
roofs, and radiated heated slab on grade floors for energy
efficiency. Photo © Eiron Schofield, Living Architecture
Project: Eastern Village Cohousing Architect: EDG Architects,
LLC Location: Bethesda,
Md. This program called for the adaptive reuse of an
office building for a mixed-use project of approximately 80,000
square feet of residential co-housing condominium units along with
15,000 square feet of live-work space in a separate wing of the
building. Typical of cohousing, the users were represented
throughout the programming and design process. The program was for
56 standard units and 11 live-work units. Half the units qualify as
workforce housing, and energy savings are passed on to residents in
the form of lower utility costs. The existing surface parking lot
was transformed into a landscaped courtyard that serves as the
building's front yard leading to the main entrance and common house.
The green screen is galvanized steel, and the green roof is a
modified IRMA roof with precast concrete pavers serving as walkways
and patio space on the roof deck. The closed-loop geothermal system
uses 40, 650-foot-deep wells to individual heat pumps. Photo© Tom
Kochel, Tom Kochel Photography
Project: New Columbia Architect: Mithun Location:
Seattle Cooperation for this project began in July 2000
when the previous development’s resident association and the local
housing authority teamed to pursue a HUD HOPE VI revitalization
grant. The community's final master plan was developed through
extensive community input and included goals for safety and
security, economic diversity, accessibility, and sustainable design.
The infrastructure package for this dense urban neighborhood
consists of public streets and utilities, an innovative stormwater
management system, and public transit that helps integrate the
formerly isolated development sensitively into the surrounding city
fabric. Building systems and materials were chosen for their
sustainable features, with extensive attention paid to energy use
and savings. The local utility is also testing a solar energy model
program using the redevelopment to gain metrics. Drawing from
regional Craftsman traditions, the housing design reflects the local
climate and local building customs. Photo © Juan Hernandez,
Mithun
Project: Little Ajax Affordable Housing Architect: Peter L. Gluck and
Partners, Architects Location: New York City This
project uses a skewed courtyard geometry to create 14 communally
oriented family units, on-site parking, and public trail
connections. Three angled “slots” slice through the courtyard block,
breaking it down into an interconnected series of house-scaled
elements. A series of second-floor walkways are punctuated by
playful bridges and lookouts and provide multiple connections to the
units, public trains, and city sidewalks. Multiple circulation
routes augment fire safety and provide privacy by ensuring that most
units are accessed without having to pass by neighboring apartments.
The design integrates a dense program into a residential
neighborhood by breaking it down from a larger scale into five
house-scale elements. It uses color and form to create a modern
insertion into a neighborhood with a mix of architectural styles,
heavy gauge corrugated metal and cement board, and bamboo floors.
The air circulation areas are located on the exterior and are built
with exterior-grade materials such as concrete and steel. Photo ©
Steve Mundinger, Steve Mundinger Photography.
Project: Trolley
Square Architect: Mostue
& Associates Architects Location:
Somerville, Mass. Trolley Square is located on the site of
a former bus storage facility in a location critical to the
development of North Cambridge. The project is composed of 40
residential units (32 for renters and 8 for homeowners) plus 2,800
square feet of commercial and community space, an underground
garage, and 4,000 square feet of open space. The project contributes
to the liveliness of its surroundings with living units that open
directly onto the streets and park. Trolley Square was designed as
an amenity for both the residents and the surrounding community.
Residential units open onto a central plaza with gardens and
seating. The city will build a public park on the site to provide a
resting spot along the adjacent bike path and connect the path to
Massachusetts Avenue. The project team was also committed to
selecting the most durable, resource-efficient materials available
within the project’s budget constraints. Photo © Yuling Wang,
Mostue & Associates Architects.
|